Dell PowerEdge M830 Owner's Manual page 58

Steps
1. If you are installing a new blade, remove the plastic cover from the I/O connector(s) and save for
future use.
2. Orient the blade so that the handle is on the left side of the blade.
3. If you are installing the full-height blade in bays 3 or 4, rotate the LCD module to the horizontal
storage position to prevent accidental damage to the LCD screen.
4. Align the guide rail on the upper edge of the blade so that the rail fits between the plastic guides on
the enclosure.
5. Slide the blade into the enclosure until the handle engages and locks the blade in place.
Figure 7. Installing a blade
1. blade
Next steps
Follow the procedure listed in the After working inside your system section.
Related Links
Safety instructions
Before working inside your system
Removing the blade
After working inside your system
58
2. enclosure