Douwe Egberts Cafitesse 60 Operator's Manual page 27

a b
Fig. 50 Releasing trough
14. Remove the trough: release the trough by
moving the red slide (fig. 50 a) to the left.
The trough (fig. 50 b) comes free at the left.
15. Rotate this part further downwards, until
you can pull the complete trough out of the
right-hand mounting towards you (fig. 51).
The trough disappears from the display.
16. Clean the trough. Remove the cover from
the trough (fig. 52 a and b). The trough may
be cleaned in a dishwasher.
17. The display shows:
"REPLACE" + .
18. Replace the cover on the trough.
19. Replace the trough in the reverse order.
Fig. 51 Remove trough
20. Push the trough upwards as far as possible
until it "clicks". The flashing of the trough in
the display stops.
21. The display shows: "PLACE RIGHT" +
Press the enter button (fig. 48 d).
22. Position an empty pot (fig. 52 c) underneath
the right-hand outlet.
23. Press the enter button (fig. 48 d). The
display shows: "PUSH * FLUSH".
24. Press the enter button (fig. 48 d). The
display shows: "FLUSH" and a flashing
"CAUTION: HOT LIQUIDS". The rinsing
water flows into the pot.
25. Then empty the pot.
26. The display shows: "PLACE LEFT" +
27. Position an empty pot (fig. 52 c) underneath
the left-hand outlet.
23
a
b
Fig. 52 Trough cover / Placing pot
28. Press the enter button (fig. 48 d). The
display shows: "PUSH * FLUSH".
29. Press the enter button (fig. 48 d).
. The display shows: "FLUSH" and a flashing
"CAUTION: HOT LIQUIDS".
The rinsing water flows into the pot.
30. Then empty the pot.
31. The display shows:
"SELECT DRINK" +
32. Check the dispenser operation by selecting
one or more products.
The dispenser is now clean and ready for use
once more.
.*
*) Optional
Points 26. till 30. only appear in the display and
have to be executed if a cold water/extra tap
water system is installed and activated.
c
.