Xerox WorkCentre 5945 User's Manual And Warranty page 105

Copy
Use the Image Shift option to move the position of the image on the output page. This is useful
when the output needs to be bound as it allows you to move the image to the left or right to leave
enough room for the binding.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen. The copy features are displayed.
5. Select the Layout Adjustment tab.
6. Select the Image Shift button.
7. Select the Image Shift option required.
• Off removes any previous Image Shift settings. This option is useful if you are
programming a complex job and want to cancel any image shift settings without
cancelling other settings you have made.
• Margin Shift moves the image up / down or left / right on the page to give larger or smaller
margins. Use the arrow buttons to enter the shift required. The amount of shift is in 1mm
(0.1") increments up to 50mm (2.0"). When copying 2-sided there are two options.
• Adjust the margin of side two independently of side one.
• Check the Mirror Side 1 checkbox if you want the side 2 shift to mirror the shift set for side
1.
• Auto Center automatically centers the scanned image on the output paper. To work
effectively, the original should be smaller than the selected output media or alternatively,
the image should be reduced.
• Use the Presets menu to select a commonly used Image Shift. Your System Administrator
can alter the preset options. Once you have selected a preset option, you can edit it using
the arrow buttons. The amount of shift is in 1mm (0.1") increments up to 50mm (2.0").
When copying 2-sided there are two options.
• Adjust the margin of side two independently of side one.
• Check the Mirror Side 1 checkbox if you want the side 2 shift to mirror the shift set for side 1.
8. Select the OK button.
9. Enter the number of prints required using the numeric keypad on the control panel.
10. Press the Start button on the control panel to scan the original.
11. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
12. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
13. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Using a User ID to Log In at the Device
Using Internet Services to find System Administrator Contact Details
Viewing the Progress and Details of a Job using the Job Status Menu
User Guide
®
WorkCentre 5945/5955
103