Table of Contents
Advertisement
NOTE: When the REC. PAPER JAM message is
displayed, always remove paper jammed in the unit
before removing the cassette.
The fixing area becomes very hot. Do not
touch any parts in the fixing area when you
are removing a paper jam.
When removing jammed paper, be careful not
to get toner on your hands or clothing. If you
do, wash it off immediately with cold water.
Do not use warm or hot water as the toner will
fix to your hands or clothes and will be harder
to remove.
The illustration below shows the area where paper jams
may occur.
[1] OUTPUT AREA
Remove any metallic jewellery before
removing any paper jams. The jewellery may
come into contact with the components inside
the unit and could cause burns or electric
shock.
NOTE: Remove any media from the stack bypass and
close the stack bypass before performing any of the
procedures on the following pages. Not doing so may
cause damage to the stack bypass.
ERROR #1 JAMS
1. Open the front cover.
7 - 2
TROUBLESHOOTING
2. Turn the fixing unit release lever in the direction
indicated by the arrow. Remove the jammed paper
from the output area.
❏ When you have removed the jammed paper,
3. Close the front cover.
ERROR #2 JAMS
[3] TONER CARTRIDGE
AREA
1. Open the paper cassette right cover.
[4] STACK BYPASS
AREA
[2] PAPER CASSETTE
RIGHT COVER AREA
❏ If you have purchased one of the optional paper
2. Remove the jammed paper from the unit by pulling
gently in the direction indicated below.
❏ If there is no jammed paper in this area, follow
3. Close the paper cassette right cover.
4. Open then close the front cover.
return the lever to its original position.
FIXING UNIT RELEASE LEVER
cassettes, open the right cover of that cassette
to check if the paper jam has occurred there
the procedure for error #3.
PAPER CASSETTE
RIGHT COVER
Advertisement
Table of Contents
