Optional) Setting The Access Limit For A Local User; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
By default, the level of a local user is determined by the management module. For example,
there is a user level in the user interface view. If a user level is not set, the user level is 0.
----End

1.8.7 (Optional) Setting the Access Limit for a Local User

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
aaa
The AAA view is displayed.
Step 3 Run:
local-user user-name access-limit max-number
The maximum number of online local users is set.
By default, the number of access users with the same user name is not restricted on the S9300.
----End

1.8.8 Checking the Configuration

Prerequisite
The configurations of the local user are complete.
Procedure
l
----End
Example
After completing the configuration of local user management, you can run the display local-
user command to view brief information about attributes of the local user.
<Quidway> display local-user
----------------------------------------------------------------------------
No.
----------------------------------------------------------------------------
0
Issue 06 (2010–01–08)
NOTE
You can run the user-interface command in the system view to enter the user interface view. For details
on the user-interface command, see "Basic Configuration Commands" in the Quidway S9300 Terabit
Routing Switch Command Reference.
Run the display local-user [ username user-name ] command to check the attributes of
the local user.
User-Name
lsj
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 AAA and User Management Configuration
State AuthMask AdminLevel
A A -
1-39