Configuring Traffic Suppression On An Interface - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
No.
1
2
3
4

10.3.2 Configuring Traffic Suppression on an Interface

Context
Do as follows on the S9300 where traffic suppression needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Traffic suppression can be configured on Ethernet interfaces or GE interfaces of the S9300.
Step 3 Run:
{ broadcast-suppression | multicast-suppression | unicast-suppression } { percent-
value | cir cir-value [ cbs cbs-value ] | packets packets-per-second }
Traffic suppression is configured.
Traffic suppression for three types of traffic can be configured on an interface of the S9300.
Select one of the following traffic suppression mode for the traffic on an interface:
l
l
l
Issue 06 (2010–01–08)
To configure traffic suppression based on the packet rate, you must select the packets
parameter.
To configure traffic suppression based on the bit rate, you must select the cir and cbs
parameters.
To configure traffic suppression based on the bandwidth percentage, you must select the
percent-value parameter.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Traffic Suppression Configuration
Data
Type and number of the interface where
traffic suppression needs to be configured
Type of traffic (broadcast, multicast, or
unknown unicast traffic) that needs to be
suppressed
Mode in which traffic is suppressed (packet
rate, bit rate, or rate percentage on a physical
interface)
Limited rate, including packet rate,
committed information rate (CIR),
committed burst size (CBS), and bandwidth
percentage
10-3