Optional) Setting The Step Of An Acl; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

11 ACL Configuration
If match-order is not used, the match order is config.
Step 3 Run:
rule [ rule-id ] { deny | permit } [ source-mac source-mac-address source-mac-
mask ] [ dest-mac dest-mac-address dest-mac-mask | type protocol-type protocol-type-
mask ]
An ACL rule is created.
----End

11.3.8 (Optional) Setting the Step of an ACL

Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
acl [ number ] acl-number
The ACL view is displayed.
Step 3 Run:
step step-value
The step of an ACL is set.
When changing ACL configurations, note the following:
l
l
----End

11.3.9 Checking the Configuration

Prerequisite
The configurations of the ACL are complete.
Procedure
l
l
----End
Example
# Run the display acl command, and you can view the ACL number, number of rules, and step,
and details of ACL rules.
11-8
The undo step command sets the default step of an ACL and re-arranges the numbers of
ACL rules.
By default, the value of step-value is 5.
Run the display acl { acl-number | all } command to check the configured ACL.
Run the display time-range { all | time-name } command to check the time range.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Security
Issue 06 (2010–01–08)