Lanier lp145n Hardware Manual page 37

Installing Options
P
Store the controller board (1) into the printer while gently pressing the
cover (2).
2
Push in the controller board firmly to align the rails in the printer's compart-
ment.
Q
Fasten all the screws which you removed in step
The printer may malfunction if the controller board is not properly installed.
R
When the power is turned on, the hard disk drive will be formatted auto-
matically.
Note
❒ Be sure to return the screwdriver to the paper tray after using it.
❒ After finishing installation, you can check whether the hard disk drive is
properly installed: Print the configuration page from the [List/Test Print]
menu. If it is installed properly, "Printer Hard Disk Drive" will appear for
"Device Connection" on the configuration page.
❒ If the hard disk drive is not installed properly, reinstall it following this
procedure. If you cannot install it properly even after attempting reinstal-
lation, contact your sales or service representative.
❒ Install the controller board carefully to prevent any malfunction.
Reference
For printing the configuration page, see "Printing the Test Page", Quick In-
stallation Guide.
26
AQV502S
AQV503S
D
.