Removing Misfed Paper - Lanier lp145n Hardware Manual

9. Removing Misfed Paper

Removing Misfed Paper
An error message appears if a paper misfeed occurs. The error message gives the
location of the misfeed.
R CAUTION:
• The inside of the machine becomes very hot. Do not touch the parts with a
"v" label (means hot surface). Touching a part with a "v" label (means hot
surface) could result in a burn.
R CAUTION:
• When pulling the paper tray out, be careful not to pull it strongly. If you do,
the tray might fall and cause an injury.
Important
❒ Misfed paper may be covered in toner. Be careful not to get toner on your
hands or clothes.
❒ Toner on prints made after removing misfed paper may be loose (inadequate-
ly fused). Make a few test prints until smudges no longer appear.
❒ Do not forcefully remove misfed paper, it will tear. Torn pieces remaining in-
side the printer will cause further misfeeds and possibly damage the printer.
❒ More than one misfed area might be indicated. In this case, check every ap-
plicable area. See the following charts shown in the illustration.
D
R
❒ If paper continues to misfeed, check the following points.
• Confirm that the setting of the paper size dial matches the size and feed di-
rection of the paper loaded in the paper tray.
• Confirm that the toner cartridge is set correctly.
❒ If paper misfeeds still occur, contact your sales or service representative.
❒ Do not leave any torn paper scraps within the printer.
C
Z
B
A
Y
U
AQV050S
117