Attaching Memory Unit Type D 128Mb, Memory Unit Type E 256Mb (Sdram Module) - Lanier lp145n Hardware Manual

Attaching Memory Unit Type D 128MB, Memory Unit Type E 256MB (SDRAM Module)

Attaching Memory Unit Type D 128MB,
Memory Unit Type E 256MB (SDRAM
Module)
R CAUTION:
• Do not touch the inside of the controller board compartment. Doing so may
cause a malfunction or a burn.
Important
❒ Be sure to install SDRAM modules after installing the hard disk drive.
❒ Before touching the memory unit, ground yourself by touching something
metal to discharge any static electricity. Static electricity can damage the
memory unit.
❒ Do not subject the memory unit to physical shocks.
❒ Available memory varies depending on a model type.
❒ Before using the new memory unit, Be sure to make settings in the printer
driver.
A
Turn off the printer.
B
Pull out the first paper tray (Tray 1) and take the screwdriver (1) from the
tray. Each screw to be removed requires this screwdriver.
AQV222S
2
27