Paper Not Supported By This Printer - Lanier lp145n Hardware Manual

Label Paper
Printer setup
Printer driver setup
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Duplex printing
Additional cautions
OHP transparencies
Printer setup
Printer driver setup
Enabled paper feeding tray This paper type can be printed only from the bypass tray.
Number of sheets that can
be set
Duplex printing
Additional cautions

Paper not supported by this printer

Avoid using the following paper as they are not supported by this printer.
• Paper meant for an ink-jet printer
• Bent, folded, or creased paper
• Curled or twisted paper
• Torn paper
• Wrinkled paper
• Damp paper
• Paper that is dry enough to emit static electricity
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [La-
bels] for the bypass tray's paper type.
Click [Labels] in the [Paper type:] list.
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
Not possible
Print speed is slightly slower compared to plain paper.
Make the following settings using the control panel:
• Press the {Menu} key, select [Paper Input], and then select [Trans-
parency] for the bypass tray's paper type.
Click [OHP Transparency] in the [Paper type:] list.
• Bypass Tray: 20
Make sure paper is not stacked higher than the paper guides in-
side the bypass tray.
Not possible
• Print speed for OHP transparencies is slower than for plain pa-
per.
• Due to switching modes, the printer will be on standby for
thirty or forty seconds after the job was received.
• We recommend that you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.
Paper Recommendations
5
69