Stopping The Machine; Adjusting The Height-Of-Cut - Toro Z Master Professional 7000 Series Operator's Manual

Figure 17
1. Motion control
lever-neutral lock position
2. Center un-lock position
Driving Backward
1. Move the levers to the center, un-locked position.
2. To go backward, slowly pull the motion control levers
rearward (Figure 17).
To go straight, apply equal pressure to both motion
control levers (Figure 17).
To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 17).
To stop, push the motion control levers to the neutral
position.

Stopping the Machine

To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the power
take off (PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake in (page ). Remember to remove
the key from the ignition switch.
3. Forward
4. Backward
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height-of-Cut

The height-of-cut is adjusted from 1-1/2 to 5 inch
(38 to 127 mm) in 1/4 inch (6 mm) increments by relocating
the pin into different hole locations.
1. Raise the height-of-cut lever to the transport position
(also the 5 inch (127 mm) cutting height position)
(Figure 18).
1. Height of cut lever
2. To adjust, remove the pin from the height-of-cut
bracket (Figure 18).
3. Select a hole in the height-of-cut bracket corresponding
to the height-of-cut desired and, insert the pin
(Figure 18).
4. Move the lever to the selected height.
22
Figure 18
2. Pin