1
3
4
Figure 48
1. Ignition-30 amp (F1)
2. Radiator fan-50 amp
(large, heavy duty fuse)
2
G012492
3. Clutch-10 amp (F3)
4. Left side fuel tank
Drive System
Maintenance
Adjusting the Tracking
The machine has a knob for adjusting the tracking located
under the seat.
Important: Adjust the handle neutral and
hydraulic pump neutral before adjusting the
tracking. Refer to Adjusting the Handle Neutral
in Controls System Maintenance (page 47) and
Adjusting the Hydraulic Pump Neutral
in Hydraulic System Maintenance (page 48).
1. Push both control levers forward the same distance.
2. Check if the machine pulls to one side. If it does, stop
the machine and set the parking brake.
3. Unlatch the seat and tilt the seat forward to access the
tracking knob.
Note: Determine the left and right sides of the
machine from the normal operating position.
4. To make the machine go right, turn the knob towards
the rightside of the machine. Refer to Figure 49.
5. To make the machine go left, turn the knob towards
the leftside of the machine. Refer to Figure 49.
6. Repeat adjustment until the tracking is correct.
38