Servicing The Engine Oil - Toro Z Master Professional 7000 Series Operator's Manual

Servicing the Engine Oil

Oil Type: High-quality detergent oil classified API Service
CD or higher for diesel engines. Do not use special additives
with recommended oils.
Crankcase Capacity: 3.9 quarts (3.7 liters)
Viscosity: See the table below:
Figure 34
Checking the Engine Oil Level
Service Interval: Before each use or daily
Note: Check the oil when the engine is cold.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Clean around the oil dipstick (Figure 35) so dirt cannot
fall into the filler hole and damage the engine.
4. Pull the oil dipstick out and wipe the metal end clean
(Figure 35).
5. Slide the oil dipstick fully into the filler tube. Pull the
dipstick out and look at the metal end (Figure 35). If
the oil level is low, slowly pour only enough oil into the
fill hole to raise the level to the full mark.
Important: Do not overfill the crankcase with
oil because this may cause engine damage. Do
not run the engine with oil below the low mark
because the engine may be damaged as a result.
1. Oil dipstick
2. Metal end
32
Figure 35
3. Rear left side of machine