Table of Contents
Advertisement
3
Figure 70
1. Front support rod
2. Locking nut
6. Carefully lower the front of the mower deck to the
ground.
7. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground
(Figure
71).
2
2
1
Figure 71
1. Mower deck
2. Hanger bracket
8. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
2
1
G014635
3. Deck bracket
2
2
3
3
G005077
3. Rear lift rod
9. Slide the mower deck out from underneath the
machine.
Note: Retain all parts for future installation.
Installing the Mower Deck
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Lift the rear of the mower deck and guide the hanger
brackets over the rear lift rod
6. Attach the front support rod to the mower deck with
the clevis pin and hairpin-cotter pin
g014635
7. Install the mower belt onto the engine pulley; refer to
Replacing the Mower-Deck Belt (page
8. Tighten the bottom 2 bolts for the mower-deck curtain
to the mower deck. Refer to
Curtain (page
g005077
46
(Figure
71).
(Figure
48).
Releasing the Mower-Deck
31).
ARK
70).
Advertisement
Table of Contents
