Listening Mode Presets - Onkyo PR-SC885 Instruction Manual

Adjusting the Listening Modes—Continued
Dolby Digital Settings
■ Dolby EX
This setting determines how Dolby EX signals are han-
dled.
Auto: When the source is Dolby EX, you can select
the Dolby EX or THX Surround EX listening
mode.
Manual: When the source is Dolby EX, you can select
any of the listening modes compatible with this
format (e.g., Dolby EX, Dolby Pro Logic IIx,
etc.).
T–D (Theater-Dimensional) Setting
■ Listening Angle
With this setting, you can optimize the Theater-Dimen-
sional listening mode by specifying the angle of the front
left and right speakers relative to the listening position.
Ideally, the front left and right speakers should be equi-
distant from the listening position and at an angle close
to one of the two available settings.
Front left speaker
Narrow: Select if the angle is less than 30 degrees.
Wide: Select if the angle is greater than 30 degrees.
LFE Level Settings
With these settings, you can set the level of the LFE
(Low Frequency Effects) channel individually for Dolby
Digital, DTS, and multichannel PCM sources. The level
can be set to –∞, –20 dB, –10 dB, or 0 dB (default).
If you find that low-frequency effects are too loud when
using one of these sources, change the setting to –20 dB
or –∞ dB.
■ Dolby Digital
Sets the level of the LFE channel for Dolby Digital
sources.
■ DTS
Sets the level of the LFE channel for DTS sources.
■ Dolby TrueHD
Sets the level of the LFE channel for Dolby TrueHD
sources.
■ DTS-HD Master Audio
Sets the level of the LFE channel for DTS-HD Master
Audio sources.
92
Front right speaker
30˚
■ DSD
Sets the level of the LFE channel for DSD sources.
■ Multich PCM
Sets the level of the LFE channel for multichannel PCM
sources. (Multichannel PCM is input via HDMI.)

Listening Mode Presets

On the Listening Mode Preset menu, you can specify a
default listening mode for each of the audio formats sup-
ported by each input selector. The AV controller will
then select the listening mode automatically depending
on the format of the input signal. You can still select the
other listening modes, although the default listening
mode will be used the next time you turn on the AV con-
troller.
INPUT SELECTOR
MACRO
1 2
REMOTE MODE
DVD VCR
TV CABLE
SAT
DIMMER
+
ENTER
CH
DISC
ALBUM
-
SETUP
PREV
CH
DISPLAY
1
Press the [RECEIVER] REMOTE
RECEIVER
MODE button, followed by the
[SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "5. Listening
Mode Preset," and then press
[ENTER].
ENTER
The Listening Mode Preset menu
appears.
5.Listening Mode Preset
1.DVD
ENTER
2.VCR/DVR
3.CBL/SAT
4.GAME/TV
5.AUX1
6.AUX2
7.TAPE
8.TUNER
9.CD
10.PHONO
3 ZONE 3
CD ZONE 2
CDR/MD
RECEIVER
DOCK RECEIVER
TAPE/AMP
SLEEP
VOL
ENTER
MUTING
]/[ ]