Selecting Audio Inputs; Specifying The Digital Signal Format - Onkyo PR-SC885 Instruction Manual

Common Functions—Continued

Selecting Audio Inputs

AUDIO SEL
If you connect a component to more than one audio
input, such as a DVD player connected to analog, digital,
multichannel, and HDMI inputs, you can use the
[AUDIO SEL] button to select which audio input you
want to use to listen to that component.
Press the [AUDIO SEL] button
repeatedly to select an audio
AUDIO SEL
input: HDMI > Auto > Multich >
Analog.
HDMI: Selects the assigned HDMI
Auto: Selects the assigned COAX-
Multich:Selects the multichannel
Analog: Selects the analog input, and
You can also use the [AUDIO SEL]
button on the AV controller.
78
REC PLAYLIST RANDOM
LISTENING MODE
STEREO SURR
REPEAT AUDIO SUBTITLE PLAY MODE
PURE A DIRECT THX ALL ST
TEST TONE CH SEL LEVEL- LEVEL+
OPEN/CLOSE VIDEO OFF
AUDIO SEL L NIGHT Re-EQ
VCR VCR DVD DVD HDD HDD
RC- 690 M
IN, and the HDMI indicator
appears on the display. (The
HDMI IN must already be
assigned to the current input
selector. See page 47.)
IAL or OPTICAL DIGITAL
IN, and the DIGITAL indica-
tor appears on the display.
(The DIGITAL IN must
already be assigned to the
current input selector. See
page 49.) If there is no digital
signal, the analog input is
used instead.
input, and the ANALOG indi-
cator appears on the display.
(The multichannel input must
already be assigned to the
current input selector. See
page 51.)
the ANALOG indicator
appears on the display.

Specifying the Digital Signal Format

1 2
STANDBY/ON
STANDBY
ZONE 2
ZONE 3
PURE AUDIO AUDIO SEL DVD VCR/DVR CBL/SAT GAME/TV
ZONE 2 OFF LEVEL TONE HDMI OUT STEREO THX
PHONES POWER
RT/PTY/TP MEMORY
ON OFF
ZONE 3 DIGITAL INPUT LISTENING MODE
Normally, the AV controller detects the format of digital
input signals automatically. However, if you experience
either of the following issues when playing PCM or DTS
sources, you can specify the signal format manually.
• If the beginnings of tracks from a PCM source are cut
off, try the PCM setting.
• If noise is produced when fast forwarding or rewind-
ing a DTS CD, try the DTS setting.
1
Press the [AUDIO SEL] button
repeatedly to select Auto.
AUDIO SEL
2
While "Auto" is shown on the dis-
play, use the Up [
[ ] buttons to select:
PCM: Only input signals in PCM
DTS: Only input signals in DTS
Auto (default): The format is detected
MASTER VOLUME
AUX 1 AUX 2 TAPE TUNER CD PHONO DISPLAY
PUSH TO OPEN
TUNING
RETURN
SETUP MIC AUX 2 INPUT
TUNING
MODE SETUP
PRESET
CLEAR
S VIDEO VIDEO L AUDIO R DIGITAL
ENTER
TUNING
] and Down
format are output, and the
PCM indicator lights up. The
indicator flashes if the input
signal is not PCM.
format are output, and the
DTS indicator lights up. The
indicator flashes if the input
signal is not DTS.
automatically. If no digital
input signal is present, the
analog input is used instead.