Resetting The Remote Controller - Onkyo PR-SC885 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Onkyo
Components Connected via
Onkyo components that are connected via
trolled by pointing the remote controller at the AV con-
troller, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Onkyo component is con-
nected with an
audio cable (RCA).
See page 42 for details.
2 Enter the appropriate remote control code
to the REMOTE MODE button.
• [DVD] REMOTE MODE button
5002: Onkyo DVD player with
• [CD] REMOTE MODE button
6002: Onkyo CD player with
• [MD] REMOTE MODE button
6008: Onkyo MD recorder with
• [CDR] REMOTE MODE button
6006: Onkyo CD recorder with
• [DOCK] REMOTE MODE button
6004: Onkyo DS-A1 RI Dock with
See the previous page for how to enter remote
control codes.
3 Press the REMOTE MODE button, point
the remote controller at the AV controller,
and operate the component.
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via
the following remote control codes:
• [DVD] REMOTE MODE button
5001: Onkyo DVD player without
• [CD] REMOTE MODE button
6001: Onkyo CD player without
• [MD] REMOTE MODE button
6007: Onkyo MD recorder without
• [CDR] REMOTE MODE button
6005: Onkyo CD recorder without
• [DOCK] REMOTE MODE button
6003: Onkyo DS-A2 RI Dock without
Note:
• If you connect an -capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote oper-
ation to work properly, you must set the Input Display
to MD or CDR, respectively (see page 49).
are con-
cable and an analog
, use
(default)
(default)
(default)
Resetting the Remote Mode Buttons
You can reset a REMOTE MODE button to its default
remote control code.
1 While holding down the REMOTE
MODE button that you want to
REMOTE MODE
reset, press the TV [
DVD VCR
The Remote indicator flashes three
CD
TV
times.
CDR/MD
CABLE DOCK
SAT
2 Press the REMOTE MODE button
again.
REMOTE MODE
The Remote indicator flashes twice,
DVD VCR
indicating that the button has been
CD
TV
reset.
CDR/MD
CABLE
DOCK
The [DVD] and [CD] REMOTE
SAT
MODE buttons are preprogrammed
with remote control codes for control-
ling Onkyo DVD players and CD play-
ers, respectively. When these buttons
are reset, the preprogrammed codes are
restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down the
[RECEIVER] REMOTE MODE but-
RECEIVER
ton, press the [STANDBY] button.
The Remote indicator flashes five
times.
STANDBY
2 Press the [RECEIVER] REMOTE
MODE button again.
RECEIVER
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
] button.
117