Remote Controller; Installing The Batteries; Using The Remote Controller - Onkyo PR-SC885 Instruction Manual

Remote Controller

Installing the Batteries

1
To open the battery compartment, press
the small hollow and slide open the cover.
2
Insert the three supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
Slide the cover shut.
Notes:
• If the remote controller doesn't work reliably, try
replacing the batteries.
• Don't mix new and old batteries or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent damage from
leakage or corrosion.
• Expired batteries should be removed as soon as possi-
ble to prevent damage from leakage or corrosion.

Using the Remote Controller

When using the remote controller, point it toward the AV
controller's remote control sensor, as shown below.
STANDBY indicator
30˚
30˚
Notes:
• The remote controller may not work reliably if the AV
controller is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
• If another remote controller of the same type is used in
the same room, or the AV controller is installed close
to equipment that uses infrared rays, the remote con-
troller may not work reliably.
• Don't put anything on top of the remote controller,
such as a book or magazine, because a button may be
pressed continuously, thereby draining the batteries.
• The remote controller may not work reliably if the AV
controller is installed in a rack behind colored glass
doors. Keep this in mind when installing.
• The remote controller will not work if there's an obsta-
cle between it and the AV controller's remote control
sensor.
Remote control sensor
AV controller
Approx. 16 ft.
(5 m)
13