Using The Sleep Timer; Using Headphones; Displaying Source Information - Onkyo PR-SC885 Instruction Manual

Common Functions—Continued

Using the Sleep Timer

With the sleep timer, you can set the AV controller so
that it turns off automatically after a specified period.
Press the remote controller's
SLEEP
[SLEEP] button repeatedly to
select the required sleep time.
You can set the sleep time from 90 to 10
minutes in 10 minute steps.
The SLEEP indicator appears on the
display when the sleep timer has been
set, as shown. The specified sleep time
appears on the display for about 5 sec-
onds, then the previous display reap-
pears.
To cancel the sleep timer, press the [SLEEP] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [SLEEP]
button. Note that if you press the [SLEEP] button while
the sleep time is being displayed, you'll shorten the sleep
time by 10 minutes.

Using Headphones

For private listening, you can connect a pair of stereo
headphones (1/4-inch phone plug) to the AV controller's
PHONES jack.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off and the Headphone
indicator lights up.
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it was already set to Pure
Audio, Mono, Stereo, or Direct, in which case it stays
the same.

Displaying Source Information

You can display various information about the current
input source as follows.
controller
DISPLAY
AV controller
DISPLAY
The following information can typically be displayed:
SLEEP indicator
Input source
Signal format*
* If the input signal is analog, no format information is
displayed. If the input signal is PCM, the sampling
frequency is displayed. If the input signal is digital but
not PCM, the signal format and the number of chan-
nels is displayed. For some digital input signals,
including multichannel PCM, the signal format, num-
ber of channels, and sampling frequency is displayed.
Information is displayed for about 3 seconds, then the
previous display reappears.
Remote
Press the [DISPLAY] button
repeatedly to cycle through the
available information.
Listening
mode
Sampling
frequency
77