Adjusting The Handle Height; Using The Mid-Size Weight Kit - Toro 30433 Operator's Manual

Adjusting the Handle Height

The handle position can be adjusted to match the
operator 's height preference.
Note:
1. Remove the hairpin cotter pin and clevis pin from the
drive lever and neutral lock (Fig. 18).
4
3
5
7
m–6639
Figure 18
1. Left handle shown
2. Neutral lock
3. Clevis pin
4. Drive lever
2. Loosen the nuts holding the swivel connected to the
speed control crank (Fig. 19).
4
5
6
Figure 19
1. Speed control rod
2. Swivel
3. Nut
3. Loosen the upper flange bolts (3/8 x 1 inch) and flange
nut securing handle to rear frame (Fig. 20).
6
1
2
5. Control rod
6. Operator Presence
Control lever (OPC)
7. Hairpin cotter
1
3
2
3
m–6602
4. Speed control crank
5. Cotter pin
6. Washer
25
4. Remove the lower flange bolts (3/8 x 1 inch) and
flange nuts securing handle to rear frame (Fig. 20).
5. Pivot handle to desired operating position and install
lower flange bolts (3/8 x 1 inch) and flange nuts into
mounting holes. Tighten all flange bolts.
7
8
9
4
2
6
Figure 20
1. Handle assembly
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
5. Upper mounting hole
6. Adjust the swivel on the speed control rod and tighten
the nuts against the swivel (Fig. 19).
7. Adjust the control rod length by rotating the control
rod in the rod fitting (Fig. 5).
8. Install hairpin cotter between drive levers and neutral
locks and into clevis pins (Fig. 18).
Note: Make sure the clevis pins are inserted into the
neutral locks.
9. Perform the hydraulic linkage adjustments when the
handle height is changed. Refer Hydraulic Linkage
Adjustments on page 36.
Using the Mid–Size Weight Kit
A weight kit is available for this machine. This kit is
optional and can be obtain from an Authorized Service
Dealer.
Installing this weight kit can improve performance on
slopes.
Note: For this machine, install the weight kit only in the
front position.
Note: The use of a Tru–Trak Sulky on this machine is
not recommended.
5
1
3
m–6600
6. Lower mounting holes
7. Low position
8. High position
9. Flange bolt, 3/8 x
1–1/4 inch