Adjusting The Handle Height; Adjusting The Cutting Height - Toro 20955 Operator's Manual

Figure 14
1. Dipstick
3. Remove the dipstick and check the oil level
If the oil level is below the Add mark on the dipstick,
slowly pour oil into the oil fill tube to raise the oil level
to the Full mark on the dipstick. Do not overfill.
4. Install the dipstick securely.

Adjusting the Handle Height

You can raise or lower the handle in 1 of 2 positions that is
more comfortable for you
Figure 15
1. Loosen both handle knobs until you can push the
square edges of the carriage bolts out of the square
holes in the handle brackets.
2. Push the knobs until they are loose.
3. Move the handle to the upper or lower height position.
4. Pull the knobs until the square edges of each carriage
bolt fits into its related square hole.
(Figure
(Figure 15).
5. Tighten the handle knobs as tight as you can.

Adjusting the Cutting Height

WARNING
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your fingers under the housing when
adjusting the cutting height.
CAUTION
If the engine has been running, the muffler will be
14).
hot and can severely burn you. Keep away from the
hot muffler.
Adjust the cutting height as desired. Set the front wheels to
the same height as the rear wheels
Note: To raise the machine, move the front cutting-height
levers rearward and the rear cutting-height levers forward.
To lower the machine, move the front cutting-height levers
forward and the rear cutting-height levers rearward.
1. Raise the machine
9
(Figure 16).
Figure 16
2. Lower the machine