Greasing And Lubrication - Toro 30433 Operator's Manual

Figure 29
1. Fuse, 10 amp

Greasing and Lubrication

Service Interval/Specification
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
How to Grease
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease into
the fittings until grease begins to ooze out of the
bearings.
5. Wipe up any excess grease.
Where to add Grease
Lubricate the grease fittings as shown on the Check
Service Reference Aid decal (Fig. 30).
1
m–5390
m–5391
Lubricating the Caster Bearings
1. Lubricate the front wheel bearings and front spindles
Greasing the PTO Drive Belt Idler and
Deck Belt Idler
1. Stop the engine, set the parking brake, remove the key
31
Figure 30
until grease begins to ooze out of the bearings
(Fig. 31).
Figure 31
and disconnect the spark plug wire(s) from the spark
plug(s).
m–6367