Checking The Hydraulic Fluid And Engine Oil; Setting Up The Hydro Linkage; Operation; Think Safety First - Toro 30433 Operator's Manual

No parts needed for this step.
Checking the Hydraulic Fluid
and Engine Oil
Check the hydraulic fluid level before the engine is first
started.
Refer to Checking the Hydraulic Fluid on page 34.
Check the engine oil level before the engine is first
started.
Refer to Checking the Engine Oil Level on page 28.
No parts needed for this step.

Setting Up the Hydro Linkage

Check the following adjustments when the machine is first
set up and adjust only as needed. Do them in the order that
they are listed here.
Checking the Speed Control Linkage
Refer to Adjusting the Speed Control Linkage on page 36.
Checking the Neutral Control Linkages
Refer to Adjusting Neutral Control Linkages on page 37.
Checking the Hydro Control Linkages
Refer to Adjusting the Hydro Control Linkages on
page 37.
Checking the Neutral Stud
Refer to Adjusting the Neutral Stud on page 39.
Checking the Control Rods
Refer to Adjusting the Control Rods on page 40.
Checking the Tracking
Refer to Adjusting Tracking on page 41.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Carefully read all the safety instructions and decals in the
safety section. Knowing this information could help you,
your family, pets or bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet
and head is recommended.
Caution
This machine produces sound levels in excess of
85dBA at the operator's ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.
1
1. Caution

Controls

Become familiar with all the controls (Fig. 9) before you
start the engine and operate the machine.
Throttle control – The throttle control has three
positions: Choke, Fast and Slow.
18
Figure 8
2. Wear hearing protection
2