Table of Contents
Advertisement
Parts needed for this step:
1 Handle assembly
2 Flange bolts, 3/8 x 1 inch
2 Flange bolts, 3/8 x 1–1/4 inch
4 Flange nuts, 3/8 inch
Installing the Handle Assembly
1. Align handle with upper mounting holes in rear frame
(Fig. 2).
2. Secure the handle at each upper mounting hole with a
flange bolt (3/8 x 1–1/4 inch) and flange nut (Fig. 2).
3. Select the low position for the lower mounting hole
(Fig. 2).
4. Secure the handle at each lower mounting hole with a
flange bolt (3/8 x 1 inch) and flange nut (Fig. 2).
Note: The handle position can be adjusted to match the
operator 's height preference.
7
8
9
4
2
6
Figure 2
1. Handle assembly
2. Rear frame
3. Flange nut, 3/8 inch
4. Flange bolt, 3/8 x 1 inch
5. Upper mounting hole
Note: Handle assembly must be installed before fuel tank
is installed.
5
1
3
m–6600
6. Lower mounting holes
7. Low position
8. High position
9. Flange bolt, 3/8 x
1–1/4 inch
15
Parts needed for this step:
1 Fuel tank with studs installed
2 Bolts, 5/16 x 7/8 inch
2 Lock washers, 5/16 inch
2 Flat washers, 5/16 inch
2 Springs
1 Hose clamp
Installing the Fuel Tank
1. Align the fuel tank with the top of the rear frame
(Fig. 4).
2. Push the fuel line through the grommet and hole in the
hydraulic oil filter bracket (Fig. 4).
3. Push the fuel line onto the fuel tank connection and
secure it with the hose clamp that is on the fuel line
(Fig. 3).
Note: To ease assembly of the fuel line to fuel tank
connection, apply a light lubricant, such as WD 40, to the
end of the fuel line.
Note: Make sure the fuel line and clamp are on as shown
in Figure 3.
3
Figure 3
1. Fuel line
2. Clamp
4. Secure the right side of the fuel tank to the rear frame
(Fig. 4) with 2 bolts (5/16 x 7/8 inch), lock washers
(5/16 inch) and washers (5/16 inch) (Fig. 4).
5. Secure the left side of the fuel tank to the rear frame
(Fig. 4) with washers (5/16 inch), springs and locknuts
(5/16 inch) (Fig. 4).
1
2
m–6504
3. Fuel tank connection
Advertisement
Table of Contents
