3. Install the basket hooks
.
Adjusting the Latch Bolt for the Handle-Height
Adjuster
If the handle-height adjuster is not parallel with the upper receiver weldment, perform the
following steps to adjust the bolt:
1. Loosen the nut
the bolt head can move freely just beyond the
pivot stop
Note:
height-adjuster spring to reduce tension on the
bolt.
Setup: Adjusting the Latch Bolt for the Handle-Height
Adjuster
over the frame loop
on the latch bolt
.
You can apply pressure to the handle-
G404689
so that
G440770
Page 3–3
3460-892 A