Adjusting The Center Gage Wheels - Toro 30433 Operator's Manual

Important All four hairpin cotter pins must be in the
same hole location and with the correct number of spacers
for a level cut.
5
1
4
2
Figure 16
1. Carrier Frame
2. Hairpin Cotter
3. Front height–of–cut post
Adjusting the Center Gage
Wheels
The gage wheels need to be adjusted in the proper hole
location for each height-of-cut position. There needs to be
3/8 inch (10 mm) minimum clearance above the ground.
1. After adjusting height-of-cut, check the gage wheels so
that there is a minimum of 3/8 inch (10 mm) clearance
above the ground (Fig. 17).
2. If adjustment is needed, remove the bolt, washers and
nut (Fig. 17).
3. Select a hole position so the gage wheels are a
minimum of 3/8 inch (10 mm) off the ground
(Fig. 17).
4. Install the bolt, washers and nut (Fig. 17).
3
4
1
2
m–5230
4. Spacers
5. Back height–of–cut post
3
4
1
Figure 17
1. Center Gage Wheels and
Spacer
2. Nut
24
4
2
m–6366
3. Bolt
4. Washer