Checking The Deck Side-To-Side Leveling; Changing The Side-To-Side Leveling; Matching Height Of Cut; Replacing The Mower Belt - Toro 30433 Operator's Manual

Checking the Deck
Side-to-Side Leveling
1. Check the tire pressure on both deck and traction unit.
2. Position the blades side-to-side (Fig. 67). Measure at A
and B locations (Fig. 67) from a level surface to the
cutting edge of blade tips (Fig. 68).
3. The difference between measurements A and B should
be no more than 1/4 inch (6 mm).
Front
A
Figure 67
MEASURE FROM
CUTTING EDGE TO
A LEVEL SURFACE
Figure 68
Changing the Side-to-Side
Leveling
Changing the side–to–side leveling is done by adjusting
tire pressure.
Changing the Side–to–Side Leveling with
Tire Pressure
1. Change the tire pressure on both deck and traction
unit. Do this to the corresponding side that needs
adjustment.
2. Recheck the front-to-rear pitch and side to side
leveling of the cutting unit.

Matching Height of Cut

1. Check the tire pressure on both deck and traction unit.
2. Set the height-of-cut to the 4 inch (101.6 mm) position
following the height-of-cut decal.
3. With the machine on level surface, position one blade
front-to-rear (Fig. 69). Measure at A and from level
surface to the cutting edge of the blade tips (Fig. 70).
4. The measurement should be 4 inch (101.6 mm).
B
m–1078
m–2550
5. If it does not measure correctly, add air pressure in rear
tires to raise height–of–cut
6. If it does not measure correctly, decrease air pressure
in rear tires to lower height–of–cut.
7. Check carrier frame front–to–rear pitch.

Replacing the Mower Belt

Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks are
signs of a worn deck belt. Replace the deck belt if any of
these conditions are evident.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the knobs and rubber washers holding the
carrier frame cover and remove the carrier frame
cover.
47
Front
A
Figure 69
MEASURE FROM
CUTTING EDGE TO
A LEVEL SURFACE
Figure 70
m–1078
m–2550