Table of Contents
Advertisement
1. Full
2. High
3.
Wipe the dipstick clean with a clean cloth.
4.
Insert the dipstick into the oil-fill tube, but do not
screw it in, then remove the dipstick.
5.
Read the oil level on the dipstick
•
If the oil level on the dipstick is too low
(Figure
11), carefully pour a small amount
of SAE 30 or SAE 10W-30 detergent oil into
the oil-fill tube, wait 3 minutes, and repeat
steps
3
through
is at the correct level.
•
If the oil level on the dipstick is too high
(Figure
11), drain the excess oil until the oil
on the dipstick is at the correct level; refer to
Changing the Engine Oil (page
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
6.
Install the dipstick into the oil-fill tube securely.
Adjusting the Handle
Height
You may raise or lower the handle to a position
comfortable for you.
Rotate the handle lock, move the handle to 1 of 3
positions, and lock the handle into position
12).
Figure 11
3. Add
(Figure
5
until the oil on the dipstick
17).
(Figure
g038772
1. Handle lock
Adjusting the Cutting
Height
11).
Adjust the cutting height as desired. Set all the
cutting-height levers to the same height. To raise and
lower the machine, refer to
1. Cutting-height lever
Important:
(1 inch); 38 mm (1-1/2 inch); 51 mm (2 inches); 64
mm (2-1/2 inches); 83 mm (3-1/4 inches); 95 mm
(3-3/4 inches); 108 mm (4-1/4 inches).
9
Figure 12
2. Handle positions
Figure
13.
Figure 13
The cutting height settings are 25 mm
g007284
g012130
Advertisement
Table of Contents
