Table of Contents
Advertisement
Brake Maintenance
Adjusting the Parking Brake
Service Interval: After the first 10 hours
Every 200 hours
1. Remove the rubber grip from the parking-brake lever
(Figure
64).
Figure 64
1. Grip
2. Loosen the set screw securing the knob to the parking
brake lever
(Figure
Figure 65
1. Knob
2. Set screw
3. Rotate the knob until a force of 20 to 22 kg (45 to 50
lb) is required to actuate the lever.
4. Tighten the set screw when finished.
Note: If no adjustment is left at the handle, loosen the
handle to the middle of the adjustment and adjust the
cable at the rear, then repeat step 3.
5. Install the rubber grip onto the parking-brake lever.
2. Parking-brake lever
65).
3. Parking-brake lever
Adjusting the Brake Pedal
Service Interval: Every 200 hours
Note: Remove the font hoot to ease the adjustment
procedure.
1. Remove the cotter pin and clevis pin securing the
master cylinder yoke to the brake-pedal pivot
66).
1. Master cylinder yoke
2. Lift up on the brake pedal
the frame.
3. Loosen the jam nuts securing the yoke to the master
cylinder shaft
(Figure
4. Adjust the yoke until its holes align with the hole in
the brake-pedal pivot.
5. Secure the yoke to the pedal pivot with the clevis pin
and cotter pin.
6. Tighten the jam nuts securing the yoke to the master
cylinder shaft.
Note: The brake master cylinder must relieve pressure
when properly adjusted.
51
Figure 66
2. Brake-pedal pivot
(Figure
67) until it contacts
67).
(Figure
Advertisement
Table of Contents
