Table of Contents
Advertisement
Hour Meter
The hour meter indicates the total hours of machine
operation. The hour meter
whenever the key switch is rotated to the O
the engine is running.
Speed-Limiter Switch
Move the speed-limiter switch
and remove the key. The switch limits the engine to 2,200
rpm when the machine is in third gear in the High range,
which limits the top speed to 21 km/h (13 mph).
Light Switch
Push the light switch
(Figure
or off.
Oil-Pressure-Warning Light
The oil-pressure-warning light glows
engine-oil pressure drops below a safe level while the engine
is running. If the light flickers or remains on, stop the vehicle,
turn off the engine, and check the oil level. If the oil level is
low, but adding oil does not cause the light to go out when
the engine is restarted, turn the engine off immediately and
contact your local Toro distributor for assistance.
Check the operation of warning lights as follows:
1. Apply the parking brake.
2. Turn the ignition key to the O
but do not start the engine.
Note: The oil-pressure light should glow red. If the
light does not function, either a bulb is burned out or
there is a malfunction in the system which must be
repaired.
Note: If engine was just turned off, it may take 1 to
2 minutes for the light to come on.
Coolant-Temperature Gauge and Light
Registers the coolant temperature in the engine. Operates
only when the ignition switch is in O
Note: The indicator light illuminates blinking red if the
engine overheats.
Charge Indicator
Illuminates when the battery is being discharged. If the light
illuminates during operation, stop the machine, turn off the
engine, and check for possible causes, such as the alternator
belt
(Figure
8).
Important: If the alternator belt is loose or broken, do
not operate the machine until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
(Figure
8) starts to function
position or if
N
(Figure
8) to the S
position
LOW
8) to toggle the headlights on
(Figure
8) if the
/P
position,
N
REHEAT
position
(Figure
N
Check the operation of warning lights as follows:
•
Apply the parking brake.
•
Turn the ignition key to the O
do not start the engine. The coolant temperature, charge
indicator, and oil-pressure lights should glow. If any light
does not function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank. It
operates only when ignition switch is in the O
(Figure
8). Red indicates low fuel level and blinking red
indicates near empty.
High-Flow-Hydraulics Switch
TC Models Only
Turn on the switch to activate the high-flow hydraulics
(Figure
8).
Horn Button
TC Models Only
Pressing the horn button activates the horn
Tachometer
Registers the speed of the engine
white triangle indicates 540 rpm for PTO operation
8).
1. Speed of the engine
Check-Engine Light
The light illuminates to notify the operator of an engine
malfunction; refer to
(page
21).
17
/P
N
REHEAT
N
(Figure
(Figure 8 andFigure
Figure 9
2. 3300 rpm for 540 rpm PTO
operation
Responding to a Check-Engine Light
position, but
position
8).
9). The
(Figure
9).
Advertisement
Table of Contents
