Table of Contents
Advertisement
Important: Check the measurements at consistent
locations on the tire. The machine should be on a
flat surface with the tires facing straight ahead.
Figure 58
1. Front of the machine
2. 0 ± 3 mm (0 ± 0.12 inch)
front to rear of the tire
3. Adjust the center-to-center distance as follows:
A. Loosen the jam nut at the center of the tie rod
(Figure
59).
Figure 59
1. Tie rods
B. Rotate the tie rod to move the front of the tire
inward or outward to achieve the center to center
distances from front to back.
C. Tighten the tie rod jam nut when the adjustment
is correct.
D. Check to ensure that the tires turn an equal
amount to the right and to the left.
Note: If the tires do not turn equally, refer to the
Service Manual for the adjustment procedure.
3. Center to center distance
2. Jam nuts
Cooling System
Maintenance
Removing Debris from the
Cooling System
Service Interval: Before each use or daily (clean more
frequently in dirty conditions).
1. Turn the engine off and clean the engine area
thoroughly of all debris.
2. Unlatch and remove the radiator screen from the front
of the radiator
(Figure
1. Radiator screen
2. Latch
3. If so equipped, rotate the latches and pivot the oil
cooler away from the radiator
1. Radiator housing
2. Oil cooler
4. Clean the radiator, oil cooler, and screen thoroughly
with compressed air.
Note: Blow debris away from the radiator. Do not use
water to clean external surfaces of the radiator.
5. Install the cooler and screen to the radiator.
49
60).
Figure 60
(Figure
61).
Figure 61
3. Latches
Advertisement
Table of Contents
