Electrical System
Maintenance
Servicing the Fuses
The fuses for the electrical system are located under the
center of the dash panel
(Figure 49
Figure 49
1. Fuses
Figure 50
1. Power outlet—10 A
2. Switched power—10 A
3. Fuel pump, supervisor
switch—10 A
4. Horn, power point—15 A
and
Figure
50).
5. Lights, brake—15 A
6. Hazard—10 A
7. 4WD, Transmission—10 A
Jump Starting the Machine
WARNING
Jump starting can be dangerous. To avoid personal
injury or damage to electrical components in
machine, observe the following warnings:
• Never jump start with a voltage source greater
than 15 VDC; this will damage the electrical
system.
• Never attempt to jump start a discharged battery
that is frozen. It could rupture or explode during
jump starting.
• Observe all battery warnings while jump-starting
your machine.
• Be sure your machine is not touching the jump
start machine.
• Connecting cables to the wrong post could
result in personal injury and/or damage to the
electrical system.
1. Squeeze the battery cover to release the tabs from the
battery base, and remove the battery cover from the
battery base
(Figure
1. Battery cover
2. Connect a jumper cable between the positive posts of
the 2 batteries
(Figure
Note: The positive post may be identified by a + sign
on top of the battery cover.
3. Connect 1 end of the other jumper cable to the negative
terminal of the battery in the other machine.
Note: The negative terminal has "NEG" on the
battery cover.
Note: Do not connect the other end of the jumper
cable to the negative post of the discharged battery.
45
51).
Figure 51
52).