Cleaning; Cleaning Under The Mower; Waste Disposal - Toro 30360 Operator's Manual

Figure 79
1. Bolt
2. Spacer
3. Locknut
4. Spring
3. Place the spacer and spring between the replacement
grass deflector brackets (Figure 79). Place the left
hand J hook end of the spring behind the deck edge.
Note: Make sure the left hand J hook end of the
spring is installed behind the deck edge before
installing the bolt as shown in Figure 79.
4. Install the bolt and nut. Place the right hand J
hook end of the spring around the grass deflector
(Figure 79).
Important: The grass deflector must be able to
lower down into position. Lift the deflector up
to test that it lowers into the full down position.
5. Spring installed
6. Grass Deflector
7. Left hand hook end of
spring, place behind deck
edge before installing bolt
8. Right hand hook end of
spring

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
Remove the grass buildup under the mower daily.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts
to stop before leaving the operating position.
3. Raise the mower to the transport position.
4. Raise the front of the machine by using jack stands.
5. Thoroughly clean the underside of the mower with
water.

Waste Disposal

Engine oil, batteries, hydraulic oil, and engine coolant
are pollutants to the environment. Dispose of these
according to your state and local regulations.
63