Controls System Maintenance; Adjusting The Control Lever Neutral Interlock Switch; Adjusting The Control Lever Neutral Return - Toro 30360 Operator's Manual

Controls System
Maintenance
Adjusting the Control Lever
Neutral Interlock Switch
1. Stop the machine, move the control levers fully into
the neutral-locked position, set the parking brake,
and remove the ignition key.
2. Remove the bolts securing the front panel and
remove the panel (Figure 59).
Figure 59
1. Front panel bolts
3. Loosen the 2 screws securing the interlock switch
(Figure 60).
Figure 60
1. Control lever
2. Neutral interlock switch
3. Screws
4. 0.015 to 0.045 inch (0.4 to
1 mm)
4. Holding the control lever against the frame, move
the switch toward the lever until the distance
between lever and switch body is 0.015 to 0.045 inch
(0.4 to 1 mm) (Figure 60).
5. Secure the switch.
6. Repeat steps 3 to 5 for the other lever.
7. Install the front panel.
Adjusting the Control Lever
Neutral Return
If the motion control levers do not align with the neutral
slots when released from the reverse drive position,
adjustment is required. Adjust each lever, spring, and
rod separately.
1. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
2. Move the throttle lever to the Slow position, stop the
engine, remove the key, and wait for all moving parts
to stop before leaving the operating position.
3. Remove the bolts securing the front panel and
remove the panel (Figure 61).
1. Front panel bolts
4. Move one of the levers to the neutral position but
not locked (Figure 63).
5. Pull the lever back until the clevis pin (on an arm
above the pivot shaft) contacts the end of the
slot (just beginning to put pressure on the spring)
(Figure 62).
53
Figure 61