Setup; Installing The Left Rear Tire (Model 30464Tc And 30363Tc Only); Activating And Charging The Battery (Model 30464Tc And 30363Tc Only) - Toro 30360 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
1
Installing the Left Rear Tire
(Model 30464TC and 30363TC
Only)
Parts needed for this procedure:
1 Tire
Procedure
1. Support the left rear of the machine with jack stands.
2. Remove the lug nuts from the tire mounting studs.
3. Pull the crate and bracket off of the wheel hub.
4. Install the rear tire onto the hub and secure it using
the lug nuts previously removed.
5. Torque the lug nuts to 75 to 80 ft-lb (102 to 108
N⋅m).
Description
Tire
No parts required
No parts required
No parts required
No parts required
No parts required
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Pre-delivery Inspection Sheet
Engine warranty
CE certificate
Qty.
Install the left rear tire (model 30464TC
1
and 30363TC only).
Activate and charge the battery (model
–
30464TC and 30363TC only).
–
Adjust the ROPS.
–
Check the tire pressure.
–
Install weights.
Check the hydraulic fluid, engine oil,
–
and coolant levels.
1
1
Read the manuals and view the
1
training materials before operating the
1
machine. Use the remaining parts for
1
the installation of attachments.
1
1
2
Activating and Charging the
Battery (Model 30464TC and
30363TC Only)
No Parts Required
Procedure
Use only electrolyte (1.265 Specific Gravity) to fill
battery initially.
1. Remove the battery from the machine.
Important: Do not add electrolyte while the
battery is in the machine. You could spill it,
causing corrosion.
2. Clean the top of the battery and remove the vent
caps (Figure 3).
14
Use