Connecting cables to the wrong post could
damage the electrical system and result in
personal injury.
Note: Ensure that the battery cables are routed
away from any sharp edges or moving parts.
3
Adjusting the ROPS
No Parts Required
Procedure
1. Remove the hairpin cotter pins and remove the two
pins from the roll bar (Figure 5).
Right Side Shown
1. Roll bar
2. Pin
2. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 5).
Note: If you must lower the roll bar, push the bar
forward to relieve pressure on the pins, remove the
pins, lower the bar slowly, and secure it with the pins
so that it does not damage the hood.
Figure 5
3. Hairpin cotter pin
4
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore,
release some of the air to reduce the pressure. The
correct air pressure is 15 psi (103 kPa) in the rear tires
and 25 psi (172 kPa) in the caster wheels.
16