Drive System Maintenance; Checking The Tire Pressure; Replacing The Castor Wheels And Bearings - Toro 30360 Operator's Manual

(refer to the decal next to the fuses (Figure 51) for a
diagram of each fuse and its amperage).
Note: If a fuse blows frequently, you probably have a
short in the electrical system and should have it serviced
by a qualified service technician.
Figure 50
1. Side panel cover
Figure 51
2. Latches
Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Every 50 hours
Check the pressure after every 50 operating hours or
monthly, whichever occurs first (Figure 52).
Maintain the air pressure in the front and rear tires. The
correct air pressure is 15 psi (103 kPa) in the rear tires
and 25 psi (172 kPa) in the caster wheels. Uneven tire
pressure can cause uneven cut. Check the tires when
they are cold to get the most accurate pressure reading.
Replacing the Castor Wheels
and Bearings
1. Obtain a new caster wheel assembly, cone bearings,
and bearing seals for your Authorized Toro
Distributor.
2. Remove the locknut from the bolt holding the castor
wheel assembly between the castor fork (Figure 53).
48
Figure 52