Unlatching The Seat; Pushing The Machine By Hand - Toro 30360 Operator's Manual

Figure 35
1. Seat suspension knob
Changing the Back Position
The back of the seat can be adjusted to provide a
comfortable ride. Position the back of the seat where it
is most comfortable.
To adjust it, turn the knob, under the right-side arm
rest, in either direction to provide the best comfort
(Figure 34).
Changing the Lumbar Support
The back of the seat can be adjusted to provide a
customized lumbar support for your lower back.
To adjust it, turn the knob, under the left-side arm
rest, in either direction to provide the best comfort
(Figure 34).

Unlatching the Seat

To access the hydraulic and other systems under the
seat, you need to unlatch the seat and swing it forward.
1. Use the seat position adjustment lever to slide the
seat all the way forward.
2. Push one of the seat latches, located behind and to
the sides of the seat, rearward to unlatch the seat
and pull forward on the top of the seat (Figure 36).
2. Operator weight setting
1. Seat latch

Pushing the Machine by Hand

If the machine breaks, runs out of fuel, etc. you may
need to push it. To do so, you first need to open the
hydraulic by-pass valves.
Important: Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
Pushing the Machine
1. Disengage the power take off (PTO) and turn
the ignition key to off. Move the levers to the
neutral locked position and apply the parking brake.
Remove the key.
2. Lift the seat.
3. Rotate each by-pass valve counterclockwise 1 turn
(Figure 37).
This allows hydraulic fluid to by-pass the pump
enabling the wheels to turn .
Important: Do not rotate the by-pass valves
more than 1 turn. This prevents valves from
coming out of the body and causing fluid to
run out.
33
Figure 36