Think Safety First - Toro 30360 Operator's Manual

There is no rollover protection when the roll bar
is in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when
absolutely necessary.
1. To lower the roll bar, remove the hairpin cotters,
push the roll bar forward against the springs, and
remove the two pins (Figure 12).
Figure 12
1. Roll bar
2. Raised position
2. Lower the roll bar to the down position (Figure 13).
3. Pin
4. Hairpin cotter
3. Install the two pins and secure them with the hairpin
cotter pins (Figure 12).
Important: Ensure that the rear part of the
seat is secured with the seat latch.
4. To raise the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 12).
5. Raise the roll bar to the upright position and install
the two pins and secure them with the hairpin cotter
pins (Figure 12).
Important: Always use the seat belt when the roll
bar is in the raised and locked position. Do not
use the seat belt when the roll bar is in the lowered
position.

Think Safety First

Please read all safety instructions and symbols in the
safety section. Knowing this information could help
you or bystanders avoid injury.
23
Figure 13