Oki MICROLINE MX Series User Manual page 331

Table 15. LCD Message Troubleshooting Table
Can User
Displayed Message
Correct?
INTERRUPT No
UNUSED VECTOR
00
INVALID ACTIVATE No
INVALID COMMAND No
LO DRV. SHORT * No
LOAD PAPER Yes
LOADING No
PROGRAM FROM
PORT XX%
Explanation
The controller Cycle power. If this
board receives an message occurred once
interrupt it does not and never again, you can
understand. ignore it. If the message
reappears or appears
consistently, contact your
authorized service
representative.
Printer detects The printer reports the
twinax protocol error.
communication
errors.
Printer detects The printer reports the
twinax protocol error; host action is
communication required.
errors.
Circuit(s) on the Contact your authorized
hammer bank or in
service representative.
the hammer bank
power cable
shorted to ground.
Printer is out of Load paper.
paper.
Status message: No action is required.
the new emulation
program is loading
into printer RAM.
XX% indicates how
much of the
program has
loaded.
Fault Messages
Solution
1
1
331