Table of Contents
Advertisement
1
1. Hood latch
7. Screw the bolt into the other arm of hood lock
bracket to lock the latch in position (Figure 6).
Tighten bolt securely but do not tighten nut.
3
2
1
1. Bolt
2. Nut
3
Installing the Throttle Stop
for CE Compliance when
Installing Optional High Lift
Blades
Parts needed for this procedure:
1
Throttle stop
1
Set screw
Procedure
1. Loosen the set screw on the throttle stop (Figure 7).
G012630
Figure 5
G012631
Figure 6
3. Arm of hood lock bracket
2. Slide the throttle stop onto the high idle stop screw
(Figure 7). The chamfered end of the throttle stop is
to be positioned outward.
1. Throttle stop
3. Start the engine and allow it to run for 5 to 10
minutes.
4. Adjust the high idle to 2650 rpm with the cutting
units disengaged.
5. Tighten the set screw.
6. Apply adhesive into the set screw to prevent
tampering.
4
Greasing the Machine
No Parts Required
Procedure
Before the machine is operated, it must be greased to
ensure proper lubrication. Refer to Lubrication section.
Failure to properly grease the machine will result in
premature failure of critical parts.
14
Figure 7
2. Set screw
Advertisement
Table of Contents
