• Steering cylinder ball joints (2) (Figure 24)
1. Top fitting on king pin
• Tie rod ball joints (2) (Figure 24)
• King pin bushings (2) (Figure 24). The top fitting
on the king pin should only be lubricated
annually (2 pumps).
• Lift arm bushings (1 per deck) (Figure 25)
• Lift cylinder bushings (2 per deck) (Figure 25)
Figure 24
Figure 25
• Cutting unit spindle shaft bearings (1 per cutting
unit) (Figure 26)
• Cutting unit carrier arm bushings (1 per cutting unit)
(Figure 26)
• Rear roller bearings (2 per cutting unit) (Figure 27 )
Important: Make sure the grease groove in
each roller mount aligns with the grease hole in
each end of the roller shaft. To help align the
groove and hole, there is also an alignment mark
on one end of the roller shaft.
31
Figure 26
Figure 27