Installing The High Height-Of-Cut Brush (Optional) - Toro Reelmaster 3100-D Series Installation Instructions Manual

6
Installing the High
Height-of-Cut Brush (Optional)
Parts needed for this procedure:
–
High height of cut brush (optional)
Procedure
Install the high height-of-cut brush, Part 115-0838 (for 27
inch cutting units) and 115-0849 (for 32 inch cutting units)
when cutting from 2.5 to 5.1 cm (1 to 2 inches) height of cut
(7 maximum spacers installed below the side plate pad).
1. If a roller brush is installed on the cutting unit,
remove the 2 bolts, washers and nuts securing the
non-drive-bearing housing to the bearing-housing
mounting bracket (Figure 20
1. Non-drive-bearing housing
Figure 19
and Figure 21).
Figure 20
2. Slide the non-drive-bearing housing and the excluder
seal off the brush shaft
1. Non-drive-bearing housing 3. Brush shaft
2. Excluder seal
3. Remove the 2 J-bolts and nuts
1. High height-of-cut brush
2. J-bolt
4. Slide the existing brush off the brush shaft
5. Loosen the 2 bolts, washers, and nuts securing the
drive-bearing housing to the bearing-housing mounting
bracket (Figure 22).
6. Slide the high height-of-cut brush onto the brush shaft
(Figure 22).
7. Clamp the brush onto the shaft with the 2 J-bolts and
nuts previously removed
Important: Insert the threaded end of the J-bolts
thru the outer holes of the brush shaft while
hooking the curved ends of the J-bolts into the
inner holes.
9
(Figure 21).
Figure 21
(Figure 22).
Figure 22
3. Loosen these bolts
(Figure
(Figure 22).
22).