1
Adjusting the Support
Rollers
No Parts Required
Procedure
Depending on what width cutting units are to be
installed on the traction, adjust the support rollers as
follows:
•
If using 27 inch cutting units, the rollers are to be
installed in the upper mounting holes of support
assembly channels
•
If using 32 inch cutting units, the rollers are to be
installed in the lower mounting holes of support
assembly channels
1
1. Support assembly channel 3. Use this hole for 32 inch
2. Use this hole for 27 inch
cutting units.
(Figure
3).
(Figure
3).
2
g019541
3
Figure 3
cutting units.
2
Replacing the Warning
Decal for CE Compliance
Parts needed for this procedure:
1
Warning decal
Procedure
On machines requiring CE Compliance, affix the CE
warning decal, Part No. 120-1683 over the standard
warning decal, Part No. 120-1686.
3
Installing the Hood Lock for
CE Compliance
Parts needed for this procedure:
1
Hood-lock bracket
2
Rivet
1
Screw, 1/4 x 2 inch
2
Flat washer, 1/4 inch
1
Locknut, 1/4 inch
Procedure
g019541
1. Unhook the hood latch from the hood-latch
bracket
(Figure
15
4).