Table of Contents
Advertisement
5. Coat both battery connections with Grafo 112X
(skin-over) grease, Toro Part No. 505-47, petroleum
jelly, or light grease to prevent corrosion. Slide the
rubber boot over the positive terminal.
6. Close the console panel and secure the latch.
WARNING
Battery terminals or metal tools could short
against metal components causing sparks.
Sparks can cause the battery gasses to explode,
resulting in personal injury.
• When removing or installing the battery, do
not allow the battery terminals to touch any
metal parts of the machine.
• Do not allow metal tools to short between
the battery terminals and metal parts of the
machine.
WARNING
Incorrect battery cable routing could damage
the machine and cables causing sparks. Sparks
can cause the battery gasses to explode,
resulting in personal injury.
• Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
• Always connect the positive (red) battery
cable before connecting the negative (black)
cable.
Battery Care
Service Interval: Every 50 hours
Important: Before welding on the machine,
disconnect the negative cable from the battery to
prevent damage to the electrical system.
Note: Check the battery condition weekly or after every
50 hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge
slowly. To clean the battery, remove it from the machine,
wash the entire case with a solution of baking soda and
water. Rinse with clear water. Coat the battery posts and
cable connectors with Grafo 112X (skin-over) grease
(Toro Part No. 505-47) or petroleum jelly to prevent
corrosion.
Fuses
The fuses are located under the operators control panel.
Unhook latch and raise operator's console panel
(Figure 40) to expose the fuses (Figure 41).
1. Latch
37
Figure 39
Figure 40
2. Operator's console panel
Advertisement
Table of Contents
