Cooling System Maintenance; Servicing The Engine Cooling System - Toro 30857 Operator's Manual

Figure 48
1. Front of traction unit
2. 1/8 inch less than rear of
tire
2. To adjust, remove the cotter pin and nut from either
tie rod ball joint (Figure 49). Remove tie rod ball
joint from axle case support.
Figure 49
1. Tie rod clamp
3. Loosen the clamps at both ends of the tie rods
(Figure 49).
4. Rotate the detached ball joint inward or outward
one (1) complete revolution. Tighten clamp at loose
end of tie rod.
5. Rotate the entire tie rod assembly the same direction
(inward or outward) one (1) complete revolution.
Tighten clamp at connected end of tie rod.
6. Install the ball joint in the axle case support and
tighten the nut finger tight. Measure toe-in.
7. Repeat procedure if necessary.
8. Tighten the nut and install a new cotter pin when
the adjustment is correct.
3. Center to center distance
2. Tie rod ball joint
Cooling System
Maintenance
Servicing the Engine Cooling
System
Service Interval: Before each use or daily
Remove debris from the engine area, oil cooler and
radiator daily. Clean them more frequently in dirty
conditions.
1. Unlatch and swing open rear screen (Figure 50).
Clean the screen thoroughly of all debris.
Note: To remove screen, lift off hinge pins.
1. Rear screen latch
2. Rotate latches (Figure 51) securing the oil cooler to
the frame.
41
Figure 50