Electrical System Maintenance; Charging And Connecting The Battery - Toro 30857 Operator's Manual

Electrical System
Maintenance
Charging and Connecting the
Battery
WARNING
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
1. Unlatch and raise the operator's console panel
(Figure 37).
Figure 37
1. Operator's console panel
DANGER
Battery electrolyte contains sulfuric acid which
is a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact
with skin, eyes or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
• Fill the battery where clean water is always
available for flushing the skin.
2. Latch
2. Connect a 3 to 4 amp. battery charger to the battery
posts. Charge the battery at a rate of 3 to 4 amperes
for 4 to 8 hours.
3. When the battery is charged, disconnect the charger
from the electrical outlet and battery posts.
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from battery.
4. Install the positive cable (red) to the positive (+)
terminal and the negative cable (black) to the negative
(-) terminal of the battery (Figure 38). Secure cables
to posts with capscrews and nuts. Make sure that the
positive (+) terminal is all of the way onto the post
and the cable is positioned snug to the battery. The
cable must not contact the battery cover. Slide the
rubber boot over the positive terminal to prevent a
possible short from occurring.
1. Positive battery cable
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
36
Figure 38
2. Negative battery cable
WARNING