Table of Contents
Advertisement
Figure 57
1. Counterbalance jumper
wires
4. With the key in the OFF position, remove the cap
from jumper wires and plug the wires together
(Figure 58).
Figure 58
5. Turn the key to the RUN position but DO NOT
start the machine.
6. The current counterbalance setting will flash on the
diagnostic light. The system allows for 3 settings.
7. The counterbalance setting is changed by using
the center Raise-Lower switch. To change the
counterbalance setting proceed as follows:
• Moving the switch forward to the lower position
and releasing it will lower the counterbalance
setting, thus increasing the effective weight of
each cutting deck in the turf
• Moving the switch rearward to the raise position
and releasing it will increase the counterbalance
setting, thus decreasing the effective weight of
each cutting deck in the turf
• After the switch is released, the diagnostic light
will flash the new counterbalance setting (1, 2,
or 3).
8. When the desired setting is attained, rotate the key
to the Off position.
2. Wire cap
9. Unplug the jumper wires, install the cap on the wires
and put the wires back into the compartment.
10. Replace the access cover.
Note: The machine cannot be operated while in
the counterbalance adjustment mode. Once the
adjustment has been completed, move the machine
to a test area and operate the machine with the
new setting. The new counterbalanced setting may
change the effective height of cut.
45
Advertisement
Table of Contents
