Table of Contents
Advertisement
Note: The decks will not lower while in the HI speed
range and they will not raise or lower if the operator is
out of the seat when the engine is running.
Throttle Control
Move the control (Figure 10) forward to increase the
engine speed and rearward to decrease the speed.
Light Switch
Press the lower edge of the switch (Figure 10) to turn on
the lights. Press the upper edge of the switch to turn
off the lights.
Glow Plug Indicator Light
When lit, the glow plug indicator light (Figure 10)
indicates that the glow plugs are on.
Engine Coolant Temperature Warning
Light
The light (Figure 10) illuminates and the cutting units
shut down (PTO disengages). If the temperature
continues to rise the engine will shut down.
Power Point
The power point (Figure 11) is used to power optional
12 volt electrical accessories.
1. Power point
2. Engine cooling fan switch
Engine Cooling Fan Switch
The machine is equipped with a hydraulically driven
auto reversing engine cooling fan. The fan switch
Figure 11
3. Bag holder
4. Hour meter
(Figure 11) has two positions R (manual reverse) and
Auto (normal) . Refer to Engine Cooling Fan Operation
in the Operation Section of manual.
Bag Holder
Use the bag holder (Figure 11) for storage.
Hour Meter
The hour meter (Figure 11) shows the total hours that
the machine has been operated.
Fuel Gauge
The fuel gauge (Figure 12) indicates the level of fuel in
the tank.
1. Fuel gauge
Seat Adjustments
Fore and Aft Adjusting Lever
Pull out on the lever to slide the seat fore or aft
(Figure 13).
Seat Arm Rest Adjusting Knob
Rotate the knob to adjust the seat arm rest angle
(Figure 13).
Seat Back Adjusting Lever
Move the lever to adjust the seat back angle (Figure 13).
Weight gauge
Indicates when the seat is adjusted to the weight of the
operator (Figure 13). Height adjustment is made by
positioning the suspension within the range of the green
region.
17
Figure 12
Advertisement
Table of Contents
